{"id":813,"date":"2013-05-30T14:32:13","date_gmt":"2013-05-30T13:32:13","guid":{"rendered":"http:\/\/www.wrigley.me.uk\/wp\/?p=813"},"modified":"2013-05-30T14:32:13","modified_gmt":"2013-05-30T13:32:13","slug":"teardown-steering-head-bearings","status":"publish","type":"post","link":"https:\/\/www.wrigley.me.uk\/2013\/05\/teardown-steering-head-bearings\/","title":{"rendered":"Teardown: Steering head bearings"},"content":{"rendered":"
<\/p>\n
With some advice from the folks on the LTD forum, I gave the top of the stem a sharp rap with a hammer and piece of wood and the stem dropped out, leaving the upper bearing behind, which then lifted out. Both races show some pitting, which looks bad but I can only just feel them with a finger tip. However, the Haynes manual says:<\/p>\n
If even the slightest amount of wear or damage is evident, the races should be replaced with new ones<\/p><\/blockquote>\n
Bearings seem to be readily available for non-crazy money, but I’m struggling to locate races. More questions!<\/p>\n
Update: found a full set of bearings, seals and races…in the US. Think I shall be taking advantage of my executive courier in August \ud83d\ude42<\/p>\n
Further progress, removed the centre stand with a lot of heat and wrestling. Something peculiar had been done to it on one side. If I want to re-use it, it will need a lot of cleaning up, possibly welding. Also removed the helmet locks and side stand switch, which all had to be drilled out. I just need to drift out the races and double-check for any remaining bushes etc to be able to start cleaning it up for painting\/coating. It’s been suggested I get a bunch of bolts and thread them in wherever there are thread in the frame, to keep out the grit and powder to avoid having to clean them out. Makes sense.<\/p>\n